Rock Bolts – Solid Bar
| Physical Properties | Minimum | Typical |
|---|---|---|
| Yield Strength | 500MPa / 200kN | 540MPa / 220kN |
| Tensile Strength | 540MPa / 220kN | 635MPa / 260kN |
| Calculated Shear Strength | 145kN | 170kN |
| Elongation (After Fracture) | 5% | 20% |
| Tensile Strength of Threaded End | 200kN |
| Mass Per Metre | 3.55kg |
| Bar Core Diameter | 23.0mm |
| Major Bar Diameter | 27.0mm |
| Cross Sectional Area | 415mm² |
| Rolled Thread | M24x3.0mm Pitch |
Key Features
- The Solid Deformed Bolt is manufactured from hot rolled reinforcing bar having rib deformations generally in a "herringbone" form.
- The Solid Deformed Bolt has a standard thread roll formed at one end.
- The solid deformed bolt is usually fully encapsulated with resin anchors, but can be effectively used with cementitious grouts.
- Corrosion protection may be provided by hot dip galvanizing or alternative coatings.
Installation Guide Lines
- 26-27mm hole diameters are preferred. If larger diameter holes are to be used, refer to "Posimix" bolts on data sheet WS.
- Hole depth is critical. Hole depth should be shorter than the bolt to allow for the height of the washer and nut.
- It is important to follow the resin anchor recommended mixing and hold times as printed on the chemical anchor cartons.
DO NOT OVER MIX.
Standard Lengths & Packaging
- Standard bolt lengths range from 600 to 3000mm in 300mm increments.
- Non-standard requirements are available by negotiation.
- Bolts are packaged in bundles with threads protected by heavy duty polyethylene bags.
- Bolt fittings, such as nuts, anti-friction washers and domed balls, are supplied fitted to rock bolts in the configuration requested.
